Prospective Boat Purchase - prop to rudder relationship? - mount and blade purchase code
As for the acquisition of unfinished back to the Assembly (350 hp) ski boat approximately 19'6 "long. Motor Set near the rear axle and Jack is pretty long." Here, after the inspection, he was surprised over the bridge ( see 4 sheets), is about a meter bar. Has anyone any idea the impact that the conversion and operation of the ship.? If the file has been) (and gear used in the hull was made in a shorter axis and thus move the proposal for a decision closer to the rudder.? "The current distance makes a difference, as the boat turns. I think that might be a ghost town.
Thank you in advance for your ideas and advice
Saturday, December 12, 2009
Mount And Blade Purchase Code Prospective Boat Purchase - Prop To Rudder Relationship?
Subscribe to:
Post Comments (Atom)
2 comments:
Can it make a difference? Yes, it works better.
the rudder does not work, the proposed thrust vector control works - like a hovercraft, returned by the diversion of water from a relatively quiet side street in the opposite direction (Newton's third law).
Rudder would be less effective in the waters of wake turbulence
jtex soooooo right rudder, preferably with clean water, ie the air intake in less turbulence TI.y.
If Stern were and the propeller was cavitation, and push everything that bubbles at the top. You would not rudder control.
It seems that the producer and I knew he pulled far as possible.
In addition to the proposal further in the body and thus lower in the water.
Post a Comment